Skip to Primary Navigation Skip to Site Navigation Skip to Main Content

Communication Technologies

Solutions for Market Segments
Products Section
Promotions Section
Support & Training Section
Resources
News & Events Section
Testing, Measuring and Facilities Locating

“Testing is a critical step towards the successful turn-up of a DSL loop. A test device can assist the service provider in all steps of DSL deployment — before, during, and after installation and turn-up…”

“Loop Management System Standard: An Automated Approach” White Paper DSL Forum July 16, 2001

The 3M™ Dynatel™ Product Family
When testing lines for DSL service, the familiar yellow Dynatel product family enables you to pinpoint the exact location of any fault and quickly diagnose it, minimizing repair time and cost. In addition, Dynatel instruments can qualify the available data rate on each line, allowing you to inventory the level of service that can be deployed. You can even capture and retain all of the diagnosis information and corresponding solutions for each line for future use.

Diagnostic Test Equipment
With 3M™ Dynatel™ Diagnostic Test Sets, full-featured POTS, wideband and DSL-specific testing can quickly, easily and accurately determine if line problems exist. If so, you can then pinpoint the location and extent of the impairment.
Locating and Marking
When qualifying outside plant facilities for DSL service, the familiar yellow 3M™ Dynatel™ product family enables you to pinpoint the exact location of any fault and quickly diagnose it, minimizing repair time and cost. In addition, 3M products are used widely to mark and identify OSP network features for accurate mapping and precise future locating.