Skip to 3M.com Primary Navigation Skip to Site Navigation Skip to Main Content
Meeting & Presentation Solutions

Intended Use for Digital Projectors

Use of this product in adverse conditions will void the product warranty.

Before operating your Digital Projector, please become familiar with the features and functionality of the unit. The 3M™ Digital Projectors are designed, built, and tested for use indoors, using 3M lamps, 3M ceiling mount hardware, and common line voltages (100V to 240V AC, 50/60 Hz).

The use of other replacement lamps, outdoor operation, or different voltages has not been tested and could damage the projector peripheral equipment and/or create a potentially unsafe operating condition.

3M Digital Projectors and Digital WallDisplay Systems are designed to operate in a normal office environment.

  • 100V - 240V AC, 50/60 Hz
  • 16° to 29° C (60° to 85° F)
  • 10-80% RH (without condensation)
  • 0-1828m (0-6000 feet) above sea level
The ambient operating environment should be free of airborne smoke, grease, oil and other contaminates that can effect the operation or performance of the projector.

IMPORTANT SAFEGUARDS

  1. Read and understand all instructions before using. Pay particular attention to areas where this symbol is shown.
    - Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
     Caution - Indicates a potentially hazardous situation which, if not avoided, could result in minor or moderate injury. It may also be used to alert against unsafe practices.
     Note - Used to emphasize important conditions or details.
  2. Close supervision is necessary when any appliance is used by or near children. Do not leave appliance unattended while in use.
  3. Never look directly into the projector lens when the lamp is on. The high output lamp produces a strong light which could damage your eyesight.
  4. Care must be taken as burns can occur from touching hot parts.
  5. Do not operate appliance with a damaged cord or if the appliance has been dropped or damaged - until it has been examined by a qualified service technician.
  6. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces.
  7. If any extension cord is necessary, a cord with a current rating at least equal to that of the appliance should be used. Cords rated for less amperage than the appliance may overheat.
  8. Always unplug appliance from electrical outlet before cleaning and servicing and when not in use. Grasp plug and pull to disconnect.
  9. To reduce the risk of electric shock, do not immerse this appliance in water or other liquids.
  10. To reduce the risk of electric shock, do not disassemble this appliance, but take it to a qualified technician when service or repair work is required. Incorrect assembly can cause electric shock when the appliance is subsequently used.
  11. Connect the appliance to a grounded outlet.
  12. Do not expose the projector to direct sunlight, or use it outside.
  13. Keep all ventilation openings free of any obstructions.
  14. Always open the lens shutter or remove lens cap when the projection lamp is on.
  15. Do not look directly into the light beam of a laser pointer (where applicable). The pointer produces a strong light which could damage your eyesight.
  16. The projection lamp contains mercury. Always dispose of it in a proper manner according to local regulations.
  17. To avoid premature lamp failure, do not change the mounting position of the projector (desktop ceiling mount or ceiling desktop mount) and continue to use the same lamp.
  18. Always operate machine on a flat, sturdy surface.