Skip to Primary Navigation Skip to Site Navigation Skip to Main Content

United States [Change]

United States > Products & Services > Electronics, Electrical, and Communications > 3M Aluminum Conductor Composite Reinforced > Installation Guide > Installation Videos

3M Aluminum Conductor Composite Reinforced

Proven Technology

Proven Benefits

News & Events

Contact Us

Top Image - Secondary Pages

Installation Equipment, Procedures and Hardware Videos

Installation Equipment

Installation Procedures and Hardware

Drum Puller Drum Puller_1 Drum Puller_2 Drum Puller_3	Bullwheel Tensioner 36 Inch BullWheel 36 Inch BullWheel Close-up
Stringing Block* 28 Inch Stringing Block 28 Inch Grounding Block 28 Inch Stringing Block on Dead End Tower 28 Inch Stringing Block at Pull Site *Consult 3M on the stringing block sizes to use per installation requirements.	Sock Splice Installing Sock Splice Installing Sock Splice Part 2 Connected Sock Splices with Swivel Connecting Sock splices with Swivel Part 2
Chain Hosts Chain Hoist used to Sag Conductor	Reel Stands Reel Stand 1 Reel Stand 2 Reel Stand 3
Conductor Grips Removing Preformed Conductor Grip Part 1 Removing Preformed Conductor Grip Part 2 Installing Preformed Conductor Grip	Cable Cutters Cutting ACCR_1 Cutting ACCR_2
Grounding Clamps Installing Cable Grounding Clamp on ACCR	Running Grounds Running Ground on 795 ACCR Running Ground on 1272 ACCR

Sagging Procedures Sag Tension with Dynometer Dynometer Installed Dynometer Installed 1	Deadending Procedures - Preformed - Thermolign™ Mark Clevis Location Install First Rods Install First Rods_Part 2 Connect Thimble Clevis to Extension Link Install Second Rods Install Second Rods Part 2
Deadending Procedures - Compression Mark Cable at cut location Cut Conductor to Length Install Aluminum Body Cable Trimming Pressing on Forging Injecting Filler Compound Pressing Aluminum Body Pressing Aluminum Body_1 Finished Dead End	Full Tension Splices - Preformed, Thermolign™ Install First Subset Finish First Subset Install Second Subset Finish Second Subset
Full Tension Splices - Compression Mark and Trim Cable File ends and Install Forging Install Aluminum Body Connect Cores with Forging Press on Forging Finish Pressing Forging Slide body Over Forging and add Compound Lubricate Aluminum Body Pressing Aluminum Body Finished Compression Splice	Conductor Jumpers, Connectors - Compression Brush_Conductor Measure, Cut and Press Attach Terminal to Dead End Conductor Jumpers, Connectors - Pad Tap Connector Pad Tap Connector Installed
Conductor Jumpers, Connectors - Parallel Grove Clamp Parallel Groove Clamp Installed Conductor Jumpers, Connectors - Jumper Support Insulator Jumper Supprt Insulator and Armor Rods Vibration Dampers Vibration Damper_1 Vibration Damper_2 Vibration Damper_3	Clipping-In Procedures _ Suspension Assemblies - Preformed, Thermolign™ Install Reinforcing Rods Hoist Conductor Remove Block Install Elastomer Insert Install Outer Rods Adjust Outer Rods Install Housing to Insulator Remove Hoist Rigging Finished Suspension Assembly

3M ACCR Home Page

Contact Us

Contact Us
Have questions?
Ready to get started?

Gridlines Newsletter

October 2009 Edition Now Available!

RUS List of Materials conditional acceptance
SAG10® users -- Data included in design software
Mumbia, India gets an upgrade

» Subscribe
» Open Gridlines Newsletter