Learn the benefits of accepting these cookies
You can change your cookie settings at any time by clicking on the Cookie Preferences link at the bottom of the page.
Some opt-outs may fail due to your browser's cookie settings. If you would like to set opt-out preferences using this tool, you must allow third party cookies in your browser settings.
By clicking Accept and Proceed, you confirm your understanding and agreement for cookie settings as indicated on the left.
Accept and Proceed
Products & Services >
Industrial Products & Solutions >
By Hand: Remove defect using 3M™ 9 Micron Abrasive Discs 260L (00127).
By Machine: using 3M™ Perfect-it™ III Microfinishing 260L 76mm P1500 (00907).
By Machine: using 3M™ Perfect-it™ Denibbing System (50666).
Printable Paint Rectification Process Board
Use 3M™ Trizact™ Fine Finishing Abrasive Discs P3000 76mm (50415) over the area to speed up polishing time.
Excess defects are removed by using 3M™ 260L Fine Finishing Discs P1200/1500 (50239/50238). Use with 3M™ Hookit™ Soft Interface Pad (05774).
Use 3M™ Trizact™ Microfinishing Discs P3000 150mm (50414) on a dampened panel to refine the sanding scratches. This will reduce risk of rework due to finish ‘dropping back’.
For more information or to discuss your specific requirements Contact Us
© 3M 2015. All Rights Reserved.