3M uses cookies on this site Detailed information on cookies and their use can be found in our Privacy Policy. You can customize the cookie-related settings at any time by clicking on Cookie Preferences in the footer of this page.

By clicking "Accept and Proceed" you acknowledge that you agree to the use of cookies on your computer

Accept and Proceed

Skip to Primary Navigation Skip to Site Navigation Skip to Main Content All 3M.com Site Map

Alloy Wheel Repair

3M technology can also be used to repair alloy wheels. This is a cost effective alternative to replacing damaged but reparable wheels.

Important Information:

  • Do NOT attempt to repair a wheel if it has split.
  • Do NOT remove an excessive amount of the aluminium during sanding as this will lead to poor shape and could also weaken the wheel.
  • When filling scuffs in the wheel only use approved filler. Standard Polyester fillers should NOT be used.

Step 1

3M Grey Scotch-brite™

Clean the wheel using 3M Grey Scotch-brite™ and warm soapy water to remove brake dust /road grime etc.

If possible push the tyre away from the rim to give better access to the damage.

Step 2

3M™ Hookit™ P180, P320 then P500 disc

Sand out the defects using 3M™ Hookit™ P180, P320 then P500 disc. This is better done using either the 76mm or 125mm size abrasive. (N.B. Care MUST be taken around the ‘spokes’ not to alter the shape.)

Step 3

3M™ Trizact™ Blending Disc

Sand the area of the wheel to be painted using a 3M™ Trizact™ Blending Disc or Scotch-Brite™ ultra fine hand pad. Mask out the tyre and valve stem.

Apply a suitable primer. (Follow paint company recommendations).

Step 4

3M™ Hand Pad 216u P800 50340

Sand primer if necessary using a 3M™ Hand Pad 216u P800 50340. Apply the colour and clearcoat.

(Follow paint company recommendations). Remove the masking and re-inflate the tyre.

For more information or to discuss your specific requirements Contact Us